Skip to main content

Gamepad Tester

AnsweredVerified By Gamepad TesterVerified By Gamepad Tester

Dark Objects Leave Black Smears On My VA Monitor

Asked by Jasper L.0 views

On my VA monitor, dark objects moving over dark backgrounds leave a smudgy black trail, especially in dark games. Your ghosting test with a dark background shows it badly, the light background looks fine. Is that fixable?

Brand
Not stated
Model
Monitor
Connection
DisplayPort
System
Windows 11
Browser
Edge 150
Short Answer

Black smearing is a known weakness of many VA panels: transitions from dark to slightly lighter shades are slow. Higher overdrive levels, a slightly higher black level or brightness, and higher refresh rates can reduce it, but it rarely disappears completely.

Verified By Gamepad TesterVerified By Gamepad Tester
Gabriel Silva
Gabriel SilvaVerified Gamepad Tester team memberGamepad Tester Team
Low Level Systems Programmer · Answered Jul 29, 2026

What you see is the classic VA trade-off. VA panels have excellent contrast and deep blacks, but many of them change slowly from very dark shades to slightly lighter ones. In dark scenes, pixels that should move from near-black to dark grey take too long, leaving a black smudge behind moving objects. On light backgrounds, transitions are faster, which matches your test.

What helps, with limits:

Overdrive. Try the next overdrive level up while watching the dark background in our ghosting test. Higher overdrive speeds up dark transitions, but watch for bright halos on lighter backgrounds.

Black level. Raising the black level or brightness very slightly keeps pixels from fully dropping to the darkest, slowest states. Some monitors have a black equaliser or dark boost setting that does something similar. Use it lightly to avoid grey-looking blacks.

Refresh rate. Running at the monitor's highest refresh rate often comes with stronger overdrive tuning.

It rarely vanishes completely on VA panels; it is part of the technology. If it bothers you in your main games, IPS or OLED panels avoid it, at the cost of IPS's lower contrast or OLED's price.

Step By Step Fix
  1. Run the ghosting test with a dark background.
  2. Increase overdrive one level and check for halos on light backgrounds.
  3. Raise black level or brightness slightly, or use a light black equaliser setting.
  4. Run the monitor at its highest refresh rate.
  5. Consider IPS or OLED if smearing bothers you in your main games.

Tested on: Applies to VA panel monitors. Behaviour reflects known VA dark transition characteristics.

Checked by Isabela Costa on . How we verify answers

Did this fix your controller?
Was this answer helpful?
Share this guide

Community Replies 3

  • Accepted Solution
    Esmeralda QuinnCommunity Member

    Faster overdrive mode helped my VA's smearing more than I expected.

  • Jasper LindholmCommunity Member

    Overdrive one step up plus black equaliser at 2 reduced it a lot. Still there in very dark scenes, but much better.

  • Rohan BhatiaCommunity Member

    Switched to OLED for dark games, smearing gone completely.

Add Your Reply

Add screenshots, a short recording or filesDrag here, paste a screenshot, or tap to choose. Up to 2 files, 8 MB each. JPG, JPEG, PNG, WEBP, GIF, TXT, LOG, PDF, JSON, MP4, WEBM
Gabriel Silva
Written and tested by

Gabriel SilvaVerified Gamepad Tester team member

Low Level Systems Programmer at Gamepad Tester

Gabriel is a low-level C programmer working on desktop input architecture. He builds native tooling that samples stick and trigger telemetry at sub-millisecond intervals, below the rate a browser can reach, which gives a reference measurement to compare a web test against. When a browser reading looks wrong, his capture is how the team confirms whether the controller, the operating system or the page is at fault. On Gamepad Tester he provides the reference measurements behind the latency and drift answers.

Native input capturesub-millisecond telemetrydesktop input architectureC and systems programming
  • 21 answers on Gamepad Tester
  • Captures native sub-millisecond stick and trigger data used as the reference for browser readings here.
  • Reviewed by Isabela Costa

The Team Behind These Answers

All 40 specialists

Each answer is written by the specialist who owns that part of the hardware, tested on a real controller, and checked by a second team member. How we verify answers

Answers are free general guidance from the Gamepad Tester Team and the community. Opening a controller or replacing a thumbstick module can void your warranty, so check the maker's support or warranty first. Battery and soldering work carries a real risk of damage or injury.

Free Controller Tests

Every test runs in your own browser with the Gamepad API. No sign up, no download, and your controller data never leaves your device.

All tools

Read Next On The Gamepad Tester Blog

All articles

Latest From The Community

The newest replies from players and the Gamepad Tester Team.

All guides