How To Protect A Basement Gaming Setup From Storm Flooding
The basement is the obvious place to put a gaming room. It is cooler, it is quieter, nobody complains about the noise…
I charge my DualSense to full, turn off the PS5, and a few days later the controller is almost flat even though I didn't use it. Is that normal or is the battery going?
A little loss over days is normal, but losing most of a charge in a few days is not. Make sure the controller actually powers off rather than staying on searching, and check for an ageing battery. Holding the PS button for about 10 seconds turns a DualSense off when it is not connected.
Some loss is normal. All lithium batteries self-discharge slowly, and a controller's electronics draw a tiny amount even when off. But going from full to nearly flat in a few days is more than that, and usually has one of two causes.
The controller is not really off. When the PS5 shuts down or goes into rest mode, the controller should turn off. But if it was last connected to something else, or a button was pressed after the console went off, it can sit searching for a connection with its light pulsing, which drains the battery faster. Check it is fully dark after the console turns off. When it is not connected to anything, holding the PS button for about 10 seconds turns it off.
The battery is ageing. An older battery with reduced capacity can show a fuller charge than it really holds and then fall quickly. If it also runs out quickly during play, that points the same way.
To check, charge it fully, make sure it is completely off, and look again after two days. If it has lost a large amount while truly off, the battery is worn and a replacement is the fix.
Tested on: Applies to DualSense CFI-ZCT1W on PS5 with current system software. Power settings per the PS5 power saving menu and Sony's DualSense support page.
Checked by Camila Ferreira on . How we verify answers
Hardware QA Lead at Gamepad Tester
Sneha leads manual hardware QA. Her lab takes controllers that arrive with no published specifications, mostly budget and mobile pads, and puts each one through the same fixed set of checks: every button and axis registers, deadzones are inside tolerance, rumble motors both run, the battery holds its claimed runtime, and the pad still passes after a charge cycle or two. Pads that fail are documented rather than quietly dropped. On Gamepad Tester she reviews the answers about cheap controllers behaving unpredictably and about battery and charging faults.
Each answer is written by the specialist who owns that part of the hardware, tested on a real controller, and checked by a second team member. How we verify answers
Answers are free general guidance from the Gamepad Tester Team and the community. Opening a controller or replacing a thumbstick module can void your warranty, so check the maker's support or warranty first. Battery and soldering work carries a real risk of damage or injury.
Every test runs in your own browser with the Gamepad API. No sign up, no download, and your controller data never leaves your device.
The basement is the obvious place to put a gaming room. It is cooler, it is quieter, nobody complains about the noise…
Long gaming sessions quickly expose controller flaws like fatigue, stick drift, wireless latency, and inconsistent…
Whether you're a casual gamer or a competitive player, a malfunctioning controller can ruin your gaming experience…
The newest replies from players and the Gamepad Tester Team.