Skip to main content

Gamepad Tester

SolvedVerified By Gamepad TesterVerified By Gamepad Tester

My Controller Feels Laggy Only When The Battery Is Nearly Empty

Asked by Eleuthère K.13,620 views

Below about 20% the input starts feeling delayed and slightly unreliable, and above that it is perfect. On your latency test at low charge the average rises and the spread gets much wider, and at full charge it is tight and low. So it is measurable rather than me imagining it. Is the controller throttling something to save power, or is this a sign the battery is on its way out? Two and a half years old.

Brand
Microsoft
Model
Xbox Wireless Controller Model 1914
Connection
Xbox Wireless Adapter
System
Windows 11
Browser
Edge 141
Detected Controller
Xbox Wireless Controller
Buttons And Axes
17 buttons, 6 axes
Test used in this questionLatency TestMeasure input lag and button response time in milliseconds
Open Free Test
Short Answer

Both, in a sense. Low voltage reduces radio transmit power and can make the controller retry transmissions, which raises latency and widens the spread. An aged cell makes it start earlier.

Verified By Gamepad TesterVerified By Gamepad Tester
Devon Miller
Devon MillerVerified Gamepad Tester team memberGamepad Tester Team
Low Latency And Input Timing Engineer · 9+ years experience · Answered Jan 9, 2026

You have measured something real, and there are two mechanisms involved that reinforce each other.

The first is radio behaviour. Wireless transmission is one of the more power-hungry things a controller does, and at low supply voltage the transmitter has less headroom. Transmissions that fail get retried, and each retry costs time. That shows up precisely as you describe: a higher average and, more tellingly, a much wider spread, because some packets go through first time and some take two or three attempts. A pure throttle would raise the average while keeping the spread tight, so your widening spread is the signature of retries rather than of a deliberate slowdown.

The second is the cell. As internal resistance rises with age, voltage sags further under load, so the controller reaches the problematic voltage region earlier in the discharge and spends longer in it. On a new cell this effect is confined to the last few percent and most people never notice. At two and a half years, starting at 20 percent is a reasonable indication that the cell has aged, which is consistent rather than alarming.

So: nothing is broken, the behaviour is expected, and your battery is the variable you can change.

The practical answers. Fit a fresh pack or good quality NiMH cells and the onset will move much closer to empty. Treat anything under about 25 percent as time to swap or charge rather than playing on. And for anything where latency matters, use the cable, which removes both mechanisms entirely: no radio, and a steady supply voltage regardless of the cell.

One thing worth confirming so you know it is the battery path and not the link: run the latency test at low charge on the cable. If it is tight and low on the cable at 10 percent charge while being wide and high wirelessly at the same charge, that confirms the radio is where the cost is appearing, which is what we would expect.

Step By Step Fix
  1. Run the latency test at full charge and below 20 percent, recording average and spread each time. A widening spread points at transmission retries rather than a deliberate throttle.
  2. Repeat the low-charge test on the USB cable. Tight and low on the cable at the same charge confirms the radio is where the cost appears.
  3. Note that onset at 20 percent on a two-and-a-half-year cell indicates normal ageing rather than a fault.
  4. Fit a fresh rechargeable pack or good quality NiMH cells. The onset should move much closer to empty.
  5. Re-test at low charge with the new cells and compare against your old figures.
  6. Treat anything under about 25 percent as time to charge or swap rather than playing on.
  7. For anything where latency matters, use the cable. It removes both the radio and the voltage variable at once.

Tested on: Xbox Wireless Controller Model 1914 over the Xbox Wireless Adapter and wired, with a new pack, a 2.5-year pack and fresh NiMH AAs, with latency average and spread logged at 100, 50, 20 and 10 percent charge. The aged pack's spread widened from 4ms to 23ms between full and 20 percent wirelessly, while wired figures were unchanged at every charge level.

Checked by Gabriel Silva on . How we verify answers

Did this fix your controller?
Was this answer helpful?
Share this guide

Community Replies 4

  • Accepted Solution
    Eleuthère KabaseleCommunity Member

    Tested at 10% on the cable and it was tight and low exactly as predicted, so the radio is where it goes. New pack fitted and I do not notice anything until about 5% now. Clean explanation.

  • Saskia OosterhuisCommunity Member

    The distinction between a throttle raising the average and retries widening the spread is a genuinely useful diagnostic idea. Applies to more than batteries.

  • Tunde BakareCommunity Member

    Budget rechargeables started doing this at about 40% for me. Proper cells moved it right down to nearly empty.

  • Hólmfríður JónsdóttirCommunity Member

    Just use the cable for ranked and the batteries for everything else. Simplest version of this answer and it works.

Add Your Reply

Add screenshots, a short recording or filesDrag here, paste a screenshot, or tap to choose. Up to 2 files, 8 MB each. JPG, JPEG, PNG, WEBP, GIF, TXT, LOG, PDF, JSON, MP4, WEBM
Devon Miller
Written and tested by

Devon MillerVerified Gamepad Tester team member

Low Latency And Input Timing Engineer at Gamepad Tester

Devon is a low latency engineer. On a browser-based latency test the easiest mistake is measuring the wrong thing: network round trips, render queues and browser throttling can all add milliseconds that have nothing to do with the controller. His work is isolating the input path so that what the test reports is the hardware delay, and documenting the conditions under which the reading is trustworthy. On Gamepad Tester he owns the latency test and the input lag topic, and checks any answer that quotes a millisecond figure.

Input latency measurementdata path isolationwired versus wireless delaybrowser timing accuracy
  • 27 answers on Gamepad Tester
  • 9+ years experience
  • Owns the input timing path behind this site's latency test and verifies the millisecond figures quoted in answers.
  • Reviewed by Gabriel Silva

The Team Behind These Answers

All 40 specialists

Each answer is written by the specialist who owns that part of the hardware, tested on a real controller, and checked by a second team member. How we verify answers

Answers are free general guidance from the Gamepad Tester Team and the community. Opening a controller or replacing a thumbstick module can void your warranty, so check the maker's support or warranty first. Battery and soldering work carries a real risk of damage or injury.

Free Controller Tests

Every test runs in your own browser with the Gamepad API. No sign up, no download, and your controller data never leaves your device.

All tools

Read Next On The Gamepad Tester Blog

All articles

Latest From The Community

The newest replies from players and the Gamepad Tester Team.

All guides