4replies
My L2 Trigger Only Reaches About Half Way, It Will Not Read Full Press
The trigger's potentiometer arm has slipped on its shaft, so the sensor is only sweeping part of its range while the trigger travels fully. It is a…
All TopicsStick Drift And Calibration 4Using Gamepad Tester Tools 4Buttons Not Responding 4Input Lag And Latency 3PC Games And Button Mapping 3Controller Reviews And Buying 2Trigger And Bumper Problems 2USB And Wired Connection 2Bluetooth And Wireless Pairing 2Vibration And Rumble Faults 1Firmware Drivers And Updates 1Repair Cleaning And Warranty 1Battery And Charging 1
5replies
My Controller Tests Perfectly Here But The Game Still Will Not See It
You are not going mad. The browser and Windows both read the controller directly, but most games read it through Steam Input or XInput, and…
4replies
The Test Page Runs Really Slowly And Stutters On My Phone
Your phone is not too old. The readings jumping is the page struggling, not your stick, so treat those results as unreliable. Close other tabs, use…
4replies
Controller Is Connected To My Phone But The Browser Test Shows Nothing
Mobile is supported, but many clip-on pads connect in a keyboard or mouse mode that browsers do not expose as a gamepad. Switch the controller to…
4replies
My Controller Works In One USB Port But Not The Other Three
Almost certainly a USB hub or controller-chip issue on those rear ports, often a USB 3 port behind an internal hub that a low-power HID device…
4replies
My Joy-Con Still Drifts After Calibrating It Three Times, What Am I Missing?
You are not doing it wrong. Calibration only re-learns the centre point, so it cannot help a stick that keeps moving away from centre. At -0.22 the…
5replies
My Xbox Controller Disconnects Every Few Minutes And Reconnects On Its Own
A drop-and-recover on a regular few-minute cycle is usually firmware or battery contact, not range. Update the controller firmware first, then check…
5replies
Is The DualSense Edge Worth The Extra Money Over A Standard DualSense?
For a non-competitive shooter player, the Edge is hard to justify at three times the price. Its real advantage is replaceable stick modules, not…
4replies
No Vibration Over Bluetooth But Rumble Works When I Plug The Cable In
Your hardware is fine. The DualSense exposes its rumble and haptics over USB on a PC but not over standard Bluetooth, so no browser can trigger them…
4replies
My Button Registers Twice When I Only Press It Once
This is switch bounce from a worn contact: it makes and breaks contact several times in one press. Cleaning sometimes fixes it, otherwise the…
4replies
Why Does My DualSense Left Stick Drift Upward When I Am Not Touching It?
A resting value of -0.18 is mechanical wear, not a calibration fault. Cleaning may buy you a few weeks, but a stick that reads past about -0.10 at…
4replies
A Firmware Update Broke My Controller, Can I Go Back To The Old Version?
You are not imagining it and you are not stuck. Microsoft publish an official firmware reversion process for exactly this. Roll back, then test the…
5replies
What Counts As A Normal Deadzone, Mine Reads 0.08 And I Do Not Know If That Is Bad
0.08 and 0.05 are both normal and nothing to act on. Pay attention above about 0.12, and treat the gap between your two sticks as the thing worth…
4replies
Right Trigger Reads As Pressed When I Am Not Touching It, Xbox Series X Controller
A trigger pinned at exactly 1.00 is almost always a dislodged spring or a shifted potentiometer arm inside the trigger assembly, not firmware. It is…
5replies
The Browser Cannot See My Controller At All, Nothing Happens On The Page
You almost certainly just need to press a button on the controller while the page is focused. Browsers deliberately hide gamepads until you give an…