Small Input Problems That Quietly Ruin Your Game Sessions
There is a particular kind of bad session that never gets diagnosed. You lose a duel you should have won. Your car…
On your joystick range test my right stick only reaches about 0.85 when I push it all the way in some directions, especially up and left. Other directions reach 1.00. In games turning feels slower in those directions. Is that wear, and can I fix it?
A stick that stops short in some directions usually has a calibration offset or wear at the end of its track. On a DualSense, range calibration with the DualShock Calibration GUI often restores full travel. Check for anything physically blocking the stick first.
Reaching full value in some directions but only 0.85 in others is a range problem, not a centre problem, and it is often fixable.
There are three common causes. The first is calibration. The controller stores where each axis ends; if that has shifted, some directions top out early. The second is wear or dirt at the far end of the potentiometer track, which can stop a direction short of full. The third is physical: a stick cap, grip or a slightly misaligned shell can stop the stick before it reaches its true edge.
Check the physical side first. Remove any stick extenders or thumb grips and test again. Push gently to the edge and feel whether something stops it early.
On a DualSense, the DualShock Calibration GUI includes range calibration as well as centre calibration. Run centre first, then range, rotating the stick slowly as instructed, and save permanently only when our range test shows every direction reaching close to 1.00.
If the shortfall remains after calibrating, the track is worn at that end, and a stick module replacement is the fix. Many games also map about 0.9 and above to full speed, so a small shortfall can matter less than the number suggests.
Tested on: Applies to DualSense CFI-ZCT1W on Windows 11 with Chrome or Edge over USB-C. Range calibration per the DualShock Calibration GUI project.
Checked by Arjun Mehta on . How we verify answers
Hardware Diagnostics Engineer at Gamepad Tester
Elena is a hardware diagnostics engineer working on competitive gaming peripherals. She designs test benches that put a number on the faults players usually describe by feel: outer deadzone error, circularity variance, uneven travel between the left and right stick, and the drift that appears only after a pad has warmed up. Her work covers custom and pro-tier hardware such as the Xbox Elite range and SCUF-style builds, where small geometry errors decide whether a shot lands. On Gamepad Tester she writes and checks the answers about deadzone readings and stick accuracy, and confirms a fix on real hardware before it is published.
Each answer is written by the specialist who owns that part of the hardware, tested on a real controller, and checked by a second team member. How we verify answers
Answers are free general guidance from the Gamepad Tester Team and the community. Opening a controller or replacing a thumbstick module can void your warranty, so check the maker's support or warranty first. Battery and soldering work carries a real risk of damage or injury.
Every test runs in your own browser with the Gamepad API. No sign up, no download, and your controller data never leaves your device.
There is a particular kind of bad session that never gets diagnosed. You lose a duel you should have won. Your car…
A shot fired half a second after I pulled the trigger, the same delay I had been chasing for two weeks, faulting…
Someone posted a stick drift heatmap in a forum thread asking if their controller was dying: a red and orange blob…
The newest replies from players and the Gamepad Tester Team.