My Edge Profiles Will Not Switch With The Function Buttons Any More
Most likely the profiles are not assigned to the shortcut slots any more, which happens after a firmware update or a settings reset. Reassign them…
Ask about stick drift, dead buttons, drifting triggers, vibration that stopped working, Bluetooth pairing or which controller to buy. Every answer is tested on real hardware and checked by the Gamepad Tester Team, and it is free.
Most likely the profiles are not assigned to the shortcut slots any more, which happens after a firmware update or a settings reset. Reassign them…
Click working while touch fails in one region means the capacitive layer or its ribbon connection is the fault, not the switch. Reseating the ribbon…
A button that works under hard pressure and misses under light pressure is a worn conductive pad or a contaminated membrane. Cleaning fixes it…
A clean stop at a consistent level is the charge circuit protecting an ageing cell, not a loose port. It is usually heat or rising internal…
The game is almost certainly reading the D-pad as a hat switch while your controller reports it as four buttons, or vice versa. Toggling Steam Input…
Individual presses perfect but simultaneous presses dropping points at the encoder board's scan rate or its report rate, not the switches. Check the…
You can dim it to its lowest setting but not switch it off entirely on a PS5. Dimming does give a small genuine battery gain, and a thin strip of…
Entirely repairable, and it is one of the cheaper fixes. A completely dead direction is a worn contact or a torn membrane dome, not a failed board…
Your phone is transmitting on the same 2.4GHz band, most likely over Wi-Fi or its own Bluetooth, right next to your adapter. Moving the adapter away…
Yes, it works, and it is a good diagnostic for exactly this. The Adaptive Controller presents as one standard gamepad, so the tester shows you what…
Not unlucky. Cheap modules commonly use thinner carbon tracks and looser gimbals, and three months is a typical life. Buy from a named repair…
The stops are mechanical and have manufacturing tolerance, so a small left-right difference at the shortest setting is normal. Check the…
Enumerating correctly with all inputs at zero usually means the pad is in an analog or digital mode the host is not reading, or it is a clone…
The reading is honest, the battery is the problem. Controllers estimate charge from voltage, and an aged cell holds voltage then collapses, which…
This is usually Safari needing a button press plus a focused window, or an old macOS build. Chrome on macOS is the reliable test. Also check nothing…
Every test runs in your own browser with the Gamepad API. No sign up, no download, and your controller data never leaves your device.